Stone curve, painted returns

Exterior painting on Wilton Crescent

The decorating problem on Wilton Crescent is knowing which face is allowed to take paint. The curved elevations on the northern side were re-faced in Portland stone in the early 20th century. Stone is not a surface to paint. Those elevations keep their original proportions, and the returns remain brick and stucco. The work, where there is painting at all, belongs on the returns that are already painted, not on the stone curve that gives the crescent its face.

The crescent, of about 1825, turns as a semicircle behind the north-east side of Belgrave Square. That curve changes access and the way a colour is read, but it does not change the material. Where previously painted stucco remains on the returns, the estate finish is BS colour 08B15. The pastel or heritage exception for private mews is not the rule for this crescent. Like-for-like recoating of already painted listed stucco usually does not need listed building consent. Painting the bare stone may. A scaffold on the footway means checking a Westminster pavement licence.

Access on a curve of Portland stone

The northern facades form a curve, re-faced in Portland stone, with brick and stucco returns that still step back from that face. Access has to reach the returns without treating the stone as a surface that can be leaned on, drilled into for decoration, or splashed with masonry paint. Steps and basement areas, where the house has them, are protected before any washing of the painted returns. The curve means a view along the crescent shows every mismatch, so protection and splash marks matter as much as on a straight terrace.

If a scaffold stands on the footway, check a Westminster pavement licence. That is the permission to confirm. The curve does not create a private working strip. Original proportions of the stone elevations are left alone while the access is planned: the job is not an opportunity to strap equipment across the Portland face for convenience. Materials for the returns come and go without being mixed against the stone. Entrances that stay open are identified on the visit, because the crescent footway is the shared edge.

What drives cost when stone and stucco meet

The cost follows the painted returns, not the prestige of the stone curve. Brick and stucco that already carry paint can need washing, cutting back, local filling and a compatible coat. Portland stone that must stay bare needs protection, which is a different kind of labour, not a painting area. Failed coating on a return is not treated as if the whole crescent elevation were stucco. Cracks, failed paint and damaged render are separate factors, and they apply only where there is a coated substrate.

Access on a curve, a possible scaffold on the footway, and the care needed where stone meets the return all move the scope. So does old paint on the stucco: sound film stays, and only flaking, chipping or dusting paint is taken off, without heat. Consent for anything currently unpainted, and confirmation that 08B15 is the finish for the previously painted stucco, are factors until they are settled. No figure is attached to the early 20th century re-facing. The stone is a constraint, not a coating quantity.

Quoting the returns, not the stone face

The site visit marks the Portland stone and the brick and stucco returns as different surfaces. The written quotation is itemised. Preparation and coating appear only against faces that are already painted. Protection of the stone, of steps and of basement areas is its own line, so it is not hidden inside a repaint rate. Bare patches on the stucco are primed. The coating has to be compatible with the existing paint. A line that says the whole crescent elevation, without that split, is the wrong quotation.

Colour is sampled on the painted return, against BS colour 08B15 where the stucco is already painted. The private-mews exception is not applied here. If a scaffold would occupy the footway, the quotation notes that a Westminster pavement licence has to be checked. Painting the stone is not an optional extra. It is absent. Like-for-like recoating of the returns can be quoted while consent for any bare face remains outside the scope.

Surfaces that take paint, and the stone that does not

Wilton Crescent, of about 1825, has elegantly curving facades forming a semicircle. The curved elevations on the northern side were re-faced in Portland stone in the early 20th century. They retain their original proportions, and they retain brick and stucco returns. The stone is the face people mean when they point at the crescent. It is also the face that does not enter the paint specification. No paint or stain goes on stonework, facing brickwork or terracotta unless that coating is approved. The returns are where previously painted stucco, if it is there, can be recoated.

Original proportions are a decorating constraint as well as a record of the building. A heavy film, a filled joint that changes the arris, or a colour carried onto the stone edge would alter the reading of the curve. The survey photographs and notes stop at material changes: stone, brick, painted stucco. Failed coating on a return is not used as evidence that the stone once was painted and therefore may be painted again. Each return is allowed its own condition. The crescent reads as a single street, and many substrates at the brush.

Preparation limited to coatings already there

Survey the return, not the stone curve, when the question is preparation for paint. Record cracks apart from failed coating, and record damaged render apart from both. Wash the painted stucco. Cut back loose material. Fill only where the substrate allows. Prime bare patches in the existing painted area. Choose a coating compatible with the paint that is already there. Stop the work at the joint with the Portland stone so that slurry, filler and splashes do not cross onto the re-facing. Steps and basement areas below the return are protected while this happens.

On those painted films, lead pigments were widely used until the 1960s. Do not overheat leaded paint with blow lamps or gas torches. Strip only what is flaking, chipping or dusting. The stone is not stripped, washed for coating, or keyed. Preparation that exists only to make paint stick is the wrong preparation for a face that should remain unpainted. If a return is brick that has stayed bare, it is recorded and left, under the same rule that withholds paint from stonework unless approval exists.

Colour 08B15 where painted stucco remains

Where previously painted stucco remains on the returns, it is finished to match BS colour 08B15. That is the estate rule used here. Private mews may use pastel or heritage colours with prior approval. This crescent is not that case, and the exception is not borrowed for a return because the stone curve feels like a special front. The sample is put on the painted wall of the return, close to the stone junction, so any clash is visible before the specification is agreed. Daylight along the curve will show a sample that is slightly off.

Sheen stays with the existing finish for a like-for-like coat. A change from matt to gloss may need listed building consent, and on a curved street a glossier return will flash each time you walk the crescent. Texture is watched for the same reason. The stone is not given a tinted sample. If someone wants the Portland face to look warmer, that is a different proposal, and it is not this decorating scope. The sample on the stucco is the only colour decision the quotation needs.

Consent before any unpainted face is coated

Like-for-like recoating of already painted listed stucco, matching paint type, texture, finish and colour, usually does not need listed building consent. That can cover a return that is already painted, in 08B15, at the same sheen. Painting a surface that is currently unpainted may need consent. Portland stone re-facing from the early 20th century is currently the stone face of the crescent. Coating it is not maintenance of a painted surface. The same caution applies to facing brick on a return that has remained bare.

Estate control points the same way. Paint or stain is not applied to facing brickwork, stonework or terracotta unless it is approved. Approval, if it were ever sought, would be a written matter for that address. It is not assumed from a neighbour, and it is not assumed from the stucco colour next to the stone. A Westminster pavement licence, where a scaffold needs the footway, does not touch this question. Consent, colour and access permission stay as separate checks, and only the painted return sits in the ordinary recoating path.

Sources

Questions about this decorating work

Can the Portland stone on the curved north side be painted?

No. The curved northern elevations were re-faced in Portland stone in the early 20th century, and they keep their original proportions. Stone is not a surface to paint. Paint or stain is not applied to stonework, facing brickwork or terracotta without approval, and painting a surface that is currently unpainted may need listed building consent. The brick and stucco returns are the faces that can take a coat, where they are already painted. Protect the stone while those returns are washed and coated. Do not key the Portland face so that a masonry film will grip.

What colour applies to the stucco returns?

Where previously painted stucco remains on the returns, the estate finish is BS colour 08B15. The allowance for pastel or heritage colours is for private mews, with prior approval, and it is not the rule for this crescent. Sample the colour on the return itself, next to the stone, and keep the sheen with the existing paint. A change from a matt finish to a gloss finish may need listed building consent. Like-for-like recoating that matches type, texture, finish and colour usually does not. The curve will show a sample that is slightly out.

How should failed paint on a return be removed?

Record the failed coating separately from cracks and from damaged render. Lead pigments were used until the 1960s, so do not overheat leaded paint with blow lamps or gas torches. Strip only paint that is flaking, chipping or dusting, and leave sound paint. Wash, cut back loose material, fill only where the substrate allows, and prime bare patches. Use a coating compatible with the film that remains. Stop at the Portland stone. If a scaffold must stand on the footway to do this safely, check a Westminster pavement licence.

Read next

Say whether the instruction is a painted return or the stone curve, then request a Wilton Crescent exterior quotation. The site visit and the written itemised quotation keep Portland stone out of the coating lines.

Start with the details

Tell us what needs decorating.

Share the property location, the surfaces involved and the finish you have in mind.

An enquiry starts a discussion. Scope, appointments and any instruction to proceed are agreed directly.

Your enquiry

The form sends your message to Hampstead Renovations.

Prefer to talk? Call 020 7101 3168 or WhatsApp 07459 345456.

Read our privacy policy about how we handle your enquiry.

CallWhatsAppQuote