Stucco, columns and friezes on this square
The surface in scope is the first-rate stucco of the terraces. Giant engaged Corinthian columns stress the centre and the ends of each side, and decorative friezes run on the most opulent fronts. A coating that fills the detail of a column, or that rounds off a frieze, changes the modelling even when the colour looks right from the garden. The survey names those features house by house, because a terrace of 11-12 houses is not a repeated bay with a shared defect. Ends and centres carry more modelling than the houses between them, and the failed areas rarely line up.
The setting is part of the brief. The square extends to nearly 10 acres and is the setting for these terraces, so a sample judged from the steps can look different from the same sample read across the garden. Steps and basement areas are protected before any washing or cutting back starts. Adjoining stone, glass and entrance iron are masked rather than given the wall coating by habit. The job is the painted stucco. It is not a licence to coat a face that is currently bare.
Preparation before a coat goes on
The elevation is surveyed before a product is chosen. Cracks are recorded apart from failed coating, and both are recorded apart from damaged render. A map of hollow or broken stucco is not the same note as a list of peeling paint. The front is washed. Loose material is cut back. Filling is done only where the substrate will take it, and it is kept shallow enough that a Corinthian capital or a frieze still reads. Bare patches are primed. The new coating has to be compatible with the paint already on the wall, not picked because a neighbouring terrace looks fresh.
Lead pigments were widely used in household paints until the 1960s, so older layers on this stucco may contain lead. Leaded paint is not overheated with blow lamps or gas torches. Sound old paint stays in place. Paint is stripped back only where it is flaking, chipping or dusting. That limit sits beside the modelling: taking a sound film off a frieze to get a bare surface is not the careful option, and it is the wrong response to a coating that is still attached. Any dust from a failed edge is kept off the steps and out of the basement areas.
BS colour 08B15 and the sheen already there
Where the stucco is already painted, the finish is BS colour 08B15, except on private mews, where a pastel or heritage colour may be approved. Belgrave Square is not that mews exception. A sample is put on the wall, in the light the terrace actually gets, and it is read against the columns and the frieze rather than against a card indoors. The sample has to sit on a cleaned patch so dirt is not mistaken for the old colour. If the papers for the house name a different reference, follow that paper, and adjust the wall sample to it.
Sheen is part of the match. Like-for-like recoating keeps the paint type, the texture, the finish and the colour. A change from a matt finish to a gloss finish may need listed building consent, even when the hue stays at 08B15. A glossier coat will pick out every filled crack on a Corinthian centre when the light comes across the square. The sample on the wall is the place to see that, before the specification is treated as agreed. Texture is judged the same way: a heavier film over a frieze is a change, not a like-for-like coat.
Consent for a further coat, not a new surface
On a listed house, a further coat that matches paint type, texture, finish and colour usually does not need listed building consent. That is the ordinary case for stucco that is already painted. The consent question opens if the work would paint a surface that is currently unpainted, or if the finish would move from matt to gloss, or from a smooth face to a textured face. Columns, friezes and the flat field of the wall can already differ in sheen. They should not be pulled into a new shared finish without that check.
Colour approval and listed building consent are not the same paper. BS colour 08B15 is the estate finish for previously painted stucco outside the private-mews exception. It does not, by itself, decide whether consent is needed, and consent does not choose the colour. Both are confirmed for the actual house before preparation starts. Nothing in a pavement permission, if a scaffold later needs the footway, stands in for either of those checks.
Access across a square of nearly 10 acres
The terraces face a garden of nearly 10 acres, with steps and basement areas between the pavement and the stucco. Access has to reach the Corinthian centres and the friezes without loading those steps or dropping debris into the basement areas. Protection is planned with the route, not after the first wash. Entrances that stay in use are identified before equipment arrives. A ladder that can touch a ground-floor bay is not a method for a frieze at the top of the terrace.
Where a scaffold would stand on the footway, a Westminster pavement licence is the permission to check. It is separate from listed building consent and from the colour rule. The wide garden setting does not make the footway available to occupy. Materials, washing water and cut-back debris are kept off the steps and out of the basement areas.
What changes the cost of this elevation
Cost moves with the condition of the stucco, not with a count of houses alone. A terrace of 11-12 houses can hide a small area of damaged render in a single bay and a wide area of failed coating in the next. Those are different tasks. Friezes and giant engaged Corinthian columns take longer to prepare than a plain field of stucco, because filler has to stop where the profile starts. Sound paint that can stay is a different labour from paint that is flaking, chipping or dusting and has to come off without heat.
Access changes the figure again. Reaching a frieze across a front that is read over nearly 10 acres of setting is not the same arrangement as a low bay beside the door. Protection of steps and basement areas, the question of a scaffold on the footway, and any consent or colour approval still open are all factors. Joinery and ironwork, if they are in the same instruction, are further lines. None of these factors is settled until the elevation has been seen.
Site visit and an itemised quotation
The quotation follows a site visit. The visit records the elevation, the cracks, the failed coating and the damaged render as separate notes, and it records which faces are already painted. Colour is sampled on the wall against BS colour 08B15, unless the house is in the private-mews exception and another colour has been approved. The written quotation is itemised. Preparation, priming of bare patches, the coating, protection, and access are separate lines. Repairs to broken stucco are not folded into the paint line.
Exclusions are written down as well. Painting a currently unpainted surface is left out unless consent has been settled. A change of sheen is left out on the same basis. Heat methods for old paint are not offered. If a scaffold would stand on the footway, the quotation notes that a Westminster pavement licence still has to be checked. The result is a scope for this front, not a generic terrace allowance.
Sources
Questions about this decorating work
Does a further coat on already painted Belgrave Square stucco need listed building consent?
Like-for-like recoating of stucco that is already painted, matching paint type, texture, finish and colour, usually does not need listed building consent. That is the ordinary case on these first-rate fronts when the new coat stays with what is already there. Painting a surface that is currently unpainted may need consent. A change from a matt finish to a gloss finish may need it as well, even if the hue stays at BS colour 08B15. Confirm both the consent position and the colour paper for the house before the sample on the wall is treated as agreed.
What colour is previously painted stucco held to on this square?
Previously painted stucco and cement rendering are finished to match BS colour 08B15, except on private mews, where a pastel or heritage colour may be used with prior approval. Belgrave Square is not that private-mews case. The sample belongs on the wall, beside the Corinthian columns and the decorative friezes, so the sheen can be seen across the garden setting of nearly 10 acres. A card indoors will not show how a glossier finish picks out filled cracks. If the house papers differ from 08B15, those papers are the ones to follow.
How should old paint on these fronts be taken off?
Lead pigments were widely used in household paints until the 1960s, so older coatings on this stucco may contain lead. Do not overheat leaded paint with blow lamps or gas torches. Leave sound paint in place. Strip paint only where it is flaking, chipping or dusting. Record that failed coating separately from cracks and from damaged render, then wash, cut back loose material, fill only where the substrate allows, and prime bare patches. The coating has to be compatible with the paint that remains, including on the friezes, where a heavy film would blunt the profile.
Read next
- Belgrave Square. The square as a place, before the decorating specification for its stucco.
- Exterior painting. How an elevation brief is separated from repairs, access and colour controls.
- Exterior painting on Eaton Square. A neighbouring square where early brick and stucco sits beside later full stucco.
- Preparing stucco for repainting. What to record on already painted stucco before a new coat is chosen.
When the columns, friezes and failed coating have been noted, request a Belgrave Square exterior quotation. The site visit and the written itemised quotation separate preparation, stucco repairs, coating and access.