Commercial decorating

Commercial decorating on Kinnerton Street

The surface in front of the painter is timber, at pavement level, on a street where pubs and shops sit among houses. The ground floor of the Wilton Arms is a timber pub front, with doors either side of a small-paned four-bay glazed front. No. 60 is a simple timber corner shopfront, divided by slender pilasters, with a splayed corner entrance. Those are the commercial faces. The joinery is specified on its own, separate from the wall above, so a system for a glazing bar is not rolled onto whatever masonry sits over the fascia. Glazing, including the small panes, is protected. Doors and the splayed entrance are left free to move.

The work happens beside residents. Around Kinnerton Street, pubs, restaurants, small shops and businesses are mixed with residential buildings, so a decorating job on the pub or the corner shop is not happening in an empty parade. Old paint on the pub joinery may contain lead: lead pigments were widely used in paints until the 1960s. That paint is not burnt off with a blow lamp or a gas torch. Sound old paint is left in place. Only paint that is flaking, chipping or dusting is stripped back. Colour is sampled on the timber, on a bar and on a pilaster, and agreed there before the whole front is coated.

Preparation of old pub joinery

Preparation of the Wilton Arms starts at the timber pub front, not at a decision to bare every member. Lead pigments were widely used until the 1960s, so the existing coating is treated as paint that may contain lead. It is not overheated with a blow lamp or a gas torch. Sound paint stays. Only paint that is flaking, chipping or dusting is stripped back, and that stripping stops at the loose material. A small-paned four-bay glazed front has a lot of bar edge. Scraping across those bars as if they were a flat panel will round them and will put dust against the glass. The bars are prepared individually, with the glass masked first.

Doors either side of the glazed front are joinery too. Their edges, thresholds and meeting stiles are kept free so that a coated door still closes. Failed coatings are recorded against soft or open timber, and decoration is not asked to rebuild a rotten stile. No. 60 is prepared on the same principle: slender pilasters are not aggressively stripped until the slenderness has gone, and the splayed corner entrance is kept able to swing. Where the corner traps damp and the paint is the part that is dusting, that part comes off. Where the paint is sound, it stays as the base for the new coat. Colour samples go on after that level of preparation is agreed, on the real timber, in the light of the street.

Shopfront detail: the pub front and the corner

The pub front is a composition of parts, and decoration has to leave the composition readable. Doors stand either side of a small-paned four-bay glazed front. The bays stay distinct. Paint is not bridged from bar to bar until the small panes look like a single sheet, and the doors are not swallowed into the glazing so that the either-side arrangement disappears. Glazing bars keep their section. Putty lines and the edge of the glass are respected rather than buried. The timber is coated, cut in cleanly to the glass, and stopped where the timber stops.

No. 60 is a simple timber corner shopfront. Slender pilasters subdivide it, and the entrance is splayed at the corner. The pilasters have to remain slender, which means paint is not built up on their faces and edges until they look squat, and preparation does not whittle them. The splay is the way the shop turns the corner. It is not straightened, boxed in, or painted as if it were a flat door on one street only. Both street faces of the corner, and the splayed entrance between them, are in the schedule. The wall above the shopfront, if it is painted at all, is a separate item from these pilasters.

Surfaces beside glazing and residents

The surfaces are timber: doors, frames, glazing bars, pilasters, the splayed entrance, fascias where they are timber, and the stall or cill under the glass where that timber is part of the front. Glass is protected, not coated. The small panes of the four-bay front multiply the length of edge that must be cut in, which is a scope fact, not a reason to spray or flood paint onto the glass and scrape it off later. Ironmongery that has to keep working is taken off or masked. The wall above the pub front and above No. 60 is named only if it is in the instruction, and it is not assumed to be the same coating as the joinery.

Because pubs, restaurants, small shops and businesses are mixed with houses, the surfaces next to the work include other people's doors, windows and paths. Those are protected, not decorated, unless the instruction names them. Dust from flaking leaded paint is contained, not brushed into a neighbour's entrance. A sample of colour on the pub joinery is not a sample for a house door beside it. The corner at No. 60 is judged from both streets, because a colour that looks right on one face can glare on the return. The schedule says whose front is whose before any of that sample is treated as agreed.

Access where shops sit among houses

The commercial front is not on a service road of its own. Residents live in the same mix of buildings, and the pub and the shop are in use as businesses. Doors either side of the glazed front, and the splayed entrance at No. 60, may need to keep working while decoration is going on. The plan says which leaf can be taken off, and how the remaining way in will serve. Materials are not stood in a house doorway that happens to be next to the pub. The small-paned front is not a place to lean boards. Protection covers glass, thresholds and the pavement edge where people pass.

If the timber front is entirely at ground level it may be reachable without a tall scaffold, but the visit is what confirms that, including the corner return at No. 60 and any fascia or wall above that has been included. Where a scaffold does stand on the footway, a Westminster pavement licence is required. This page states no cost for the licence. A tight street of houses and pubs is a poor place to assume the footway is spare. The quotation names the access after the premises have been seen, and it keeps that access separate from the painting of the joinery.

Cost factors for a small commercial front

Cost follows the joinery and its condition, and no figure is stated here. A small-paned four-bay glazed front has far more edge, bar and glass to protect than a single sheet of glazing, and doors either side add leaves, frames and edges that must stay free. Slender pilasters and a splayed entrance at No. 60 are more exacting than a plain rectangular opening. Lead in old coatings, and the rule that only flaking, chipping or dusting paint is stripped, change the preparation. Sound paint left in place is a different scope from a full strip, and it is the scope these fronts should have unless the paint is actually failing.

Working beside residents and beside a trading pub or shop adds protection and a way of phasing the doors. A corner adds the return. Access adds a pavement licence if a scaffold must stand on the footway. None of this is a figure on this page. A change to the pilasters, the splay or the pattern of small panes would be a different and larger instruction than redecorating the timber, and it is not quietly included. Samples, masking of the small panes, and cutting the joinery off from the wall above are all factors in the same list.

Consent, and how much old paint comes off

Decorating these fronts is not permission to remake them. The four-bay pattern, the doors either side, the slender pilasters and the splayed entrance are the front. Painting does not justify losing a bay, thickening a pilaster until the drawing changes, or squaring off a splayed entrance because a flat opening would be easier to coat. If the building is listed, a change of that kind, or a change of colour and finish, needs its own check before work starts. This page does not treat a coat of paint as that check. The written instruction should say whether the appearance stays as it is.

How much paint comes off is its own limit. Lead pigments were widely used until the 1960s, so old pub joinery is not burnt clean. Sound paint is left. Only paint that is flaking, chipping or dusting is stripped back. Stripping sound leaded paint is not a consent to be more thorough, and it is not better preparation. It is the wrong preparation. The quotation states that limit in words, so that a later wish to take the front back to bare timber is seen as a change of scope, not as something the original instruction already allowed. Glazing and neighbours are protected while the loose paint comes off.

A written itemised quotation after the site visit

The quotation is written after the pub front and the corner shop have been seen. The visit records the doors either side of the small-paned four-bay glazed front, the condition of the bars, and whether the paint is sound or is flaking, chipping or dusting. It records No. 60 as a timber corner with slender pilasters and a splayed entrance, from both streets. It notes that the premises sit among houses, restaurants and other small businesses, and it says which doors must stay in use. It does not specify the wall above as joinery, and it does not add house fronts that were not instructed.

Itemised lines cover protection of glazing, preparation that leaves sound paint and takes back only what is flaking, chipping or dusting, coatings for doors, bars and pilasters, making sure moving parts stay free, and access, including a pavement licence where a scaffold will stand on the footway. Exclusions name burning off, a full strip of sound paint, and any alteration of the splay, the pilasters or the bay pattern. Old coatings are described as paint that may contain lead, with no blow lamp and no gas torch. The figure comes from the visit, not from this page.

Sources

Questions about this decorating work

How is the timber pub front specified?

The ground floor of the Wilton Arms is a timber pub front, with doors either side of a small-paned four-bay glazed front. Those parts are the schedule. The small panes are protected, and paint is cut in to the glass rather than flooded across it. The bays stay distinct, and the doors either side stay readable as doors. Edges are left free so the doors still close. Lead pigments were widely used in paints until the 1960s, so old coatings are not burnt off. Sound paint remains. Only flaking, chipping or dusting paint is stripped.

What should happen to sound old paint on the pub joinery?

It should stay. Only paint that is flaking, chipping or dusting is stripped back, and sound old paint is left in place as the base for the next coat. That limit matters because lead pigments were widely used until the 1960s, and pub joinery of this kind is old enough that the coating may contain lead. The paint is not overheated with a blow lamp or a gas torch. Scraping sound paint off the small-paned bars, or off the slender pilasters at No. 60, would also soften the very sections the front is made of. The quotation says what is loose and what is left.

How is the corner shopfront at No. 60 kept intact?

No. 60 is a simple timber corner shopfront, subdivided by slender pilasters, with a splayed corner entrance. Decoration keeps each of those facts true. The pilasters stay slender, so paint is not built up until they look heavy, and they are not stripped back beyond flaking, chipping or dusting material. The splay is not squared off. Both faces of the corner are in the schedule, and the entrance is left free to move. Glazing is protected. The joinery is separate from the wall above. Because shops and pubs here are mixed with houses, the work is planned so neighbouring doors are not blocked.

Read next

When the pub bars, the doors and the splayed corner have been seen beside the houses, ask for a written Kinnerton Street pub and shop quotation. It should itemise the timber, the loose paint only, and the protection a mixed street requires.

Start with the details

Tell us what needs decorating.

Share the property location, the surfaces involved and the finish you have in mind.

An enquiry starts a discussion. Scope, appointments and any instruction to proceed are agreed directly.

Your enquiry

The form sends your message to Hampstead Renovations.

Prefer to talk? Call 020 7101 3168 or WhatsApp 07459 345456.

Read our privacy policy about how we handle your enquiry.

CallWhatsAppQuote