Preparation of brick, iron and stucco
Preparation does not start by coating the stock brick to make the terrace look even. The brick is recorded as brick. Where a coating has already been put on facing brick without approval, that is noted as a condition to ask about, not as a precedent the next coat should follow. Square-headed sashes are timber joinery set in the brick opening. Failed coatings on that joinery are taken back only where they have let go, and sound paint is left in place. The sash is eased so that it still slides when the work is finished. Meeting rails and the edges that pass one another are kept clear of a film thick enough to jam them. Glazing is protected before any of that preparation begins.
Cast-iron anthemion balconies are prepared as iron, not as brick and not as stucco. Loose scale and failed coatings are recorded, and the anthemion pattern is kept, which means it is not clogged until it reads as a flat bar. Joints that must move are not sealed shut. Stucco pilasters at Nos. 81-93 are prepared as stucco: a failed coating is noted against damaged render, sound stucco is left, and the pilaster profile is kept sharp enough to go on subdividing the houses. Shopfront joinery at ground floor is a separate line from the brick wall above, with its own preparation. Colour is sampled on the iron, on the stucco and on the sash, and it is not sampled on the facing brick.
Access while the ground floor is in use
The ground floor is a run of small shops and cafes. The audit gives Elizabeth Street that lively commercial character together with Eccleston Street, so the elevation is occupied during the day. The pavement is not treated as an empty yard. Shop doors stay usable, or the plan says which door is out of use and how people still enter. Glazing to the shops is protected before any work above it. Drips, dust and flakes of old coating are kept off the threshold and off whatever sits behind the glass. Materials are not stood in the only way into a shop.
Balconies and the moulded cornice sit above that occupied ground floor, so access has to reach them without using the shopfront as a prop. Where a scaffold stands on the footway, a Westminster pavement licence is required for the address. This page states no cost for that licence. Upper sashes, balcony iron and the cornice are not specified as if they could be coated from the pavement alone. The quotation names the access after the visit, because a shop opening and a full terrace bay do not share one arrangement, and because the brick itself is not a surface being reached in order to paint it.
Elevation detail on the brick terraces
The elevation is a simple stock-brick terrace: square-headed sashes, a moulded cornice, and shops at ground floor set below cast-iron anthemion balconies. That is the order the painter reads, from the shop at the pavement up to the cornice, with the balcony iron as a line between. The brick is the ground of that composition and stays unpainted. The sashes are square-headed, so the joinery is not altered into a different head while it is being decorated. The cornice is recorded as its own band. If it is stone, it is not painted. If it is already painted stucco or render, it is recoated as that material, and the profile is kept so the moulding still casts its shadow.
Nos. 81-93 are the run where stucco pilasters subdivide the individual houses. Those pilasters are the elevation detail on that part of the street. They should still read as separators when the paint is dry. The brick panel between them is not coated to match, and the pilaster is not feathered out onto the brick until the subdivision disappears. Anthemion balconies are cast iron with a recognisable pattern. Decoration follows the pattern. It does not replace the pattern with a plain bar. Railings in the conservation area are painted black, and where that area rule is being followed the balcony iron is finished black as well, rather than picked out in a contrasting colour.
Consent, and faces that stay unpainted
Painting a currently unpainted surface on a listed building is likely to need listed building consent. That includes facing brick which is bare now, whether or not it carried paint at some earlier time. The stock brick of these terraces is the surface the audit describes, and giving it a coat is not ordinary upkeep of a painted face. The same warning sits on unpainted stone. The question is asked before any such coat, not after a patch of colour has already covered the brick. A decorator who is asked to 'even the terrace up' by painting the brick stops and writes the request down as a consent matter.
Alongside that, paint or stain is not applied to facing brickwork, stonework or terracotta unless it has been approved. Approval and listed building consent are not the same conversation, and neither stands in for the other. Railings throughout the conservation area are painted black, and that consistent colour is part of their character. Changing that black, or painting the facing brick behind the railings, is outside a straightforward recoat of sash joinery and stucco pilasters. The site visit separates those requests so that a quotation for decoration is not also, by silence, a quotation for a change the controls do not allow.
Surfaces the coating may cover
Surfaces that can take a coat are the ones already finished as painted elements. Square-headed sash joinery, cast-iron anthemion balconies, railings where they are in the instruction, stucco pilasters at Nos. 81-93, and any moulded cornice that is already painted render rather than stone, are the usual list. Shopfront joinery at ground floor is a further surface, held apart from the brick wall above it. Each line records the material, the existing coating and the defects. A failed coating on a pilaster is not an invitation to extend paint onto the brick beside it.
Surfaces that do not take a coat are the facing stock brick, unpainted stonework and terracotta. Glazing is protected rather than painted. Moving parts of sashes, shop doors and balcony iron are kept free. Colour samples are placed on the sash, the iron and the stucco, and they are read in the light of the street, against the brick rather than instead of it. The sample is a patch on the real material. It is not a reason to coat the whole bay before the colour has been agreed. Where a shopfront meets the brick, the cut line is agreed on site so the joinery system stops where the joinery stops.
Cost factors, stated without a figure
Cost follows the surfaces and their condition, and this page states no figure. Sash joinery along a terrace is a different body of work from a single door. Anthemion iron is a more exacting surface than a plain rail, because the pattern has to remain legible. Stucco pilasters add a modelled face, and damaged render under a failed coating adds repair that sound stucco does not need. Brick that must stay bare reduces the painted area, and it also adds the care of cutting in so that paint does not creep onto the facing brick. Shops that stay open add protection of glass and of the way in.
Access is a factor where balconies and the cornice cannot be reached from the pavement, and where a scaffold on the footway needs a Westminster pavement licence. Consent is a factor if anyone proposes to paint currently unpainted brick or stone, because that is likely to need listed building consent, and because paint or stain on facing brickwork, stonework or terracotta also needs approval. The black of the railings, where the area rule applies, is a specification. A wish to leave that black is not itself a cost, but a wish to change it is a different instruction. No figure is attached to any of these factors here.
A written itemised quotation after the site visit
The quotation is written after the elevation has been seen. The visit confirms whether the instruction includes the stock-brick terrace, the pilastered run at Nos. 81-93, the balconies, the sashes, the cornice, the railings, or the ground-floor shops. It records which faces are brick to be left, which are stucco, and which iron is to be finished black in line with the railings. It does not guess a cornice material from the pavement opposite. Failed coatings are written against damaged render where the pilasters need it, and against loose paint on sashes and iron where that is the real defect.
Itemised lines cover preparation of joinery, preparation of iron, preparation and repair of the stucco pilasters, coatings for each of those, protection of glazing and of shops open during the day, and access, including a pavement licence where the scaffold stands on the footway. Exclusions name the facing brick, unpainted stone and terracotta. If a coat on bare brick is being asked for, the quotation says that consent and approval sit in front of that request, and it does not treat the request as agreed decoration. The figure comes from that visit. It is not invented on this page.
Sources
Questions about this decorating work
Can the stock brick on Elizabeth Street be painted?
No. The terraces are simple stock brick, and that brick is the face the elevation is built from. Paint or stain is not applied to facing brickwork, stonework or terracotta unless it has been approved. Painting a currently unpainted surface on a listed building is likely to need listed building consent, including brick that is bare now even if it was painted at some earlier time. The decorator's surfaces are the square-headed sashes, the cast-iron anthemion balconies, railings where the area rule keeps them black, and the stucco pilasters at Nos. 81-93. Those pilasters do not justify a coat on the brick between them.
What colour should the balcony iron and the railings be?
Railings throughout the conservation area are painted black, and that consistent colour is treated as part of their character. The cast-iron anthemion balconies sit on the same stock-brick fronts, below the moulded cornice and above the ground-floor shops. Where that area rule is the one being followed, the balcony iron is finished black as well, and the anthemion pattern is kept legible rather than clogged or picked out in another colour. A change away from black is a different instruction and is not assumed. The sample, if one is needed, is judged on the iron in the street.
How is the elevation painted while the shops are open?
Elizabeth Street has a lively commercial ground floor of small shops and cafes, shared in the audit's description with Eccleston Street, so the front is occupied during the day. Shop doors are kept usable, or the plan names the door that must close and how people still get in. Glazing is protected, and shopfront joinery is prepared apart from the brick wall above. Balconies, sashes and the cornice are reached by access planned for that height. Where a scaffold stands on the footway, a Westminster pavement licence is required, and this page states no cost for it. The quotation itemises protection and access after the visit.
Read next
- Elizabeth Street brick terraces and shopfronts in London. The street page sets out the brick terraces and the ground-floor shops this exterior work has to respect.
- Shopfront decorating along Elizabeth Street in London. Shopfront joinery on the same street is a separate schedule from the brick wall above it.
- Exterior painting. The wider exterior service covers masonry, iron and the access questions that sit with them.
- Repainting railings and basement areas, Belgravia in London. That guide stays with black railings and balcony iron, which on this street includes the anthemion pattern.
When the brick, the pilasters, the balcony iron and the open shops have been seen, ask for a written Elizabeth Street exterior quotation. It should itemise joinery, iron, stucco and footway access, and it should leave the facing brick unpainted.