Sashes, doors and porticos

Woodwork painting on Chester Square

Woodwork painting on Chester Square starts at the joinery, not at a wish to refresh the whole front. The houses are two windows wide and three storeys, with attic and basement, so there are fewer openings than on a wider terrace, but each opening can be more than a single sash. The audit records sash windows with side lights. Porticos have an unusual capital, which has to keep its profile if it is painted at all. What must stay is the shape of that timber and that capital, and the way the sashes still slide.

Across these terraces, most houses have single-glazed timber sliding sashes, recessed in the reveal and painted white, most commonly square-headed and six-over-six. That six-over-six pattern is the area pattern, not a Chester-only count of panes. On this square the recorded difference is the side light. Doors are painted timber and panelled. Regular painting of timber doors and windows is how decay is kept in check. Lead pigments were used until the 1960s. Leaded paint is not burned off. A scaffold on the footway means checking a Westminster pavement licence.

Consent on timber that is already painted

Like-for-like recoating of an already painted listed surface, matching paint type, texture, finish and colour, usually does not need listed building consent. White sashes that are already white, and panelled doors that are already painted, sit in that ordinary case when the new coat matches. Painting timber that is currently unpainted may need consent, even if someone believes it was painted long ago. A bare bead, a bare capital, or a face inside a side light that has never carried paint is flagged before a brush is opened.

Sheen is part of the same test. A change from a matt finish to a gloss finish may need listed building consent. Window joinery on these terraces is painted white, and the sample has to show the sheen as well as the hue, on the sash itself rather than on a loose board indoors. The unusual portico capital is not given a new finish simply because the door is being painted. If the capital is bare, it stays bare until consent says otherwise. Consent is not implied by a pavement permission.

Reaching side lights and portico capitals

A house two windows wide can still need careful access, because the sash may have side lights and the opening is recessed in the reveal. Three storeys, with attic and basement, put some of that timber well above the door and some of it beside the area. External faces of upper sashes are not a lean from the landing. Steps and basement areas are protected so that dust and flakes from cutting back do not fall into the area. The portico capital, with its unusual detail, is masked and reached without standing on the moulding.

If a scaffold is the way to reach the upper sashes, and it would stand on the footway, a Westminster pavement licence is the permission to check. The licence is not consent to change the joinery colour, and it is not a reason to paint extra faces once the access exists. Side lights on the lower storey may be reachable without that scaffold. They are still itemised, because an easy reach is not the same as a sound cill. Doors that must stay usable during the work are named before the visit ends.

What drives the cost of this joinery

Cost follows the pieces, not the room count. Side lights add painted faces beside the main sash. A six-over-six pattern, where that is what the opening actually has, adds glazing bars. The area pattern is commonly six-over-six, but the Chester Square record to follow is the sash with side lights, so the quotation does not invent bars the window does not have. Failed putty, soft edges and paint that is flaking are different from sound paint that only looks tired. Decayed timber is not a paint line.

Other factors are the unusual portico capital, the panelled door, access to attic and basement openings, protection of steps and areas, and whether old paint must be taken back without heat. Lead-bearing films until the 1960s make the method a factor, not a footnote. Consent still open, or a scaffold that needs the footway, also changes the scope. A narrow house is not automatically a small quotation. Two windows can mean two complex openings. These are factors only, with no figure attached.

How the woodwork quotation is set out

The site visit lists every sash, every side light, every door face and the portico, and it says which faces are external. The written quotation is itemised. Preparation, priming of bare timber, the finishing coat and access are separate. Repairs that are not paint, such as a failed joint or a rotten cill, are excluded or described as excluded. The area pattern of white, recessed, single-glazed sliding sashes is the starting description. The side lights are the local addition. Six-over-six is written only where that configuration is actually there.

Colour and sheen are sampled on the joinery. White for the sashes is the recorded finish, checked against the existing film rather than assumed from the terrace opposite. A move from matt to gloss is not introduced in the quotation as a quiet upgrade. If upper faces need a scaffold on the footway, the paper notes that a Westminster pavement licence has to be checked. That permission stays outside the coating line. The quotation is for the timber on this house.

Sashes, side lights and panelled doors

Most terraced houses have single-glazed timber sliding sashes, recessed within the reveal and painted white. Configurations vary, and the common area pattern is a square-headed six-over-six sash. Chester Square's own record is the sash with side lights, on houses that are only two windows wide. The side light is extra painted timber in the same opening, often easier to miss when someone counts windows from the pavement. Each light is listed. So is the meeting rail, the cill and the frame, because a coat on the sash alone leaves the reveal looking unfinished and unprotected.

Front doors are painted timber and panelled. Panels, mouldings, edges and the frame are separate faces, especially where the door stands in a portico with an unusual capital. The capital is protected whether or not it is timber. If it is already painted, it is prepared with the same limit as the door: sound paint stays, loose paint goes. If it is not painted, it is not started. Regular painting of the doors and the windows is the maintenance the audit treats as essential so that decay is not left to flourish. The coating is not a repair for timber that has already failed.

Preparation without burning old paint

Survey the joinery before choosing a coating. Record failed coating separately from decayed timber, in the same spirit as recording failed coating separately from damaged render on a wall. Wash dirt off so the sample and the defects are honest. Cut back loose material. Fill only where the timber will take it, and not to the point of rounding a glazing bar or a panel mould. Prime bare patches. The new coating has to be compatible with the existing paint. A product chosen only because it is white is not yet a specification.

Lead pigments were widely used until the 1960s. Do not overheat leaded paint with blow lamps or gas torches. Burning is not a way to clear a sash, a side light or a panelled door. Strip paint only where it is flaking, chipping or dusting. Sound paint, including in the recess of the reveal, stays. Dust is kept out of the basement area and off the steps. The unusual capital is not scraped back to a crispness it no longer has if that means cutting into the material. Preparation stops at what is loose.

White windows, and the sheen of the area pattern

The recorded colour for these sashes is white, on single-glazed timber sliding sashes set back in the reveal. The sample is brushed on the sash, or on a discreet part of the frame, and looked at in the recess, where the light is different from the face of the stucco. Side lights need the same white, unless an existing finish on that light is genuinely different and the instruction is to match it. Inventing a contrast between the main sash and the side light is not the area pattern.

Six-over-six describes the common arrangement of panes on these terraces. It is not a claim that every Chester Square window is six-over-six. Where bars are present they are coated along their edges so the slide is not glued by paint. Sheen is agreed at the same time. A change from matt to gloss may need consent, and it will show on a white sash more quickly than on a deep-coloured door. The panelled door can take a different sheen from the sash only when that difference already exists or is approved. The wall sample, if stucco is in a separate instruction, does not set the joinery sheen.

Sources

Questions about this decorating work

Are Chester Square sashes six-over-six?

Not as a Chester-only fact. Across the terraces, sashes are most commonly square-headed and six-over-six, and most are single-glazed timber sliding sashes, recessed in the reveal and painted white. That is the area pattern. What the audit records on Chester Square itself is the sash with side lights, on houses two windows wide and three storeys tall, with attic and basement. List the side lights as extra faces. Write six-over-six only where that is the window in front of you. Do not add glazing bars in the quotation because the wider area is often built that way.

Can old paint on a sash or door be burned off?

No. Lead pigments were widely used in household paints until the 1960s, so older joinery coatings may contain lead. Do not overheat leaded paint with blow lamps or gas torches. Leave sound paint in place, including on glazing bars and in the reveal. Strip only paint that is flaking, chipping or dusting. Then prime bare patches and use a coating compatible with what remains. Regular painting of timber doors and windows limits decay. It is not a reason to strip every previous coat, and it is not a repair for timber that has already softened.

Does painting the portico include a bare capital?

Only if that capital is already painted and the coat is like-for-like. Chester Square porticos have an unusual capital detail, and the profile has to survive filling and paint. Like-for-like recoating of an already painted listed surface usually does not need listed building consent. Painting a surface that is currently unpainted may. A change from matt to gloss may as well. Sample the finish on the joinery, protect the capital if it is to stay bare, and keep steps and basement areas covered while loose paint is cut back. Access does not decide the consent.

Read next

List the sashes, side lights and door faces you want coated, then ask for a Chester Square joinery quotation. The site visit and the written itemised quotation keep decayed timber, bare capitals and ordinary recoating apart.

Start with the details

Tell us what needs decorating.

Share the property location, the surfaces involved and the finish you have in mind.

An enquiry starts a discussion. Scope, appointments and any instruction to proceed are agreed directly.

Your enquiry

The form sends your message to Hampstead Renovations.

Prefer to talk? Call 020 7101 3168 or WhatsApp 07459 345456.

Read our privacy policy about how we handle your enquiry.

CallWhatsAppQuote